Jump to content


sabresfan39

Member Since 29 Sep 2008
Offline Last Active Sep 15 2009 02:46 PM
-----

Posts I've Made

In Topic: Question about my gun.

05 November 2008 - 05:00 PM

Attached File  gun1.jpg   63.17KB   9 downloads

In Topic: Question about my gun.

05 November 2008 - 04:56 PM

yes. I have the Special Edition if that makes any difference. This photo isnt of my gun, but it has the missing part that i need. if you look down by the asa and follow it to the macroline you will see a taller grey thing at the very edge of where it meets the macroline. that is what blew off. if the pic didnt post then disregard the picture.Attached File  post_1993_1222795425_thumb.jpg   2.93KB   0 downloads

In Topic: Question about my gun.

05 November 2008 - 04:39 PM

I meant the grey plastic part of the asa where you would push down to release the macroline.

In Topic: UL frame on 07 PMR SE

01 October 2008 - 03:32 PM

Thanks guys for all of your help i finally got it to fit on the gun after almost two months. But lucky me i need a longer macroline because the asa won reach the back of the frame. lol

In Topic: UL frame on 07 PMR SE

29 September 2008 - 08:32 PM

Cut the rubber piece off the bottom of the noid. Its normal, Unfortunately they don't tell you in the installation manual to cut it off. But really it doesn't do anything on the UL Frame or for the noid, It just holds the trigger spring in place on the original frame.


When i cut the rubber piece the trigger is still pushed down so should i adjust the trigger or should i do something else?