Jump to content


devaldoog

Member Since 17 Jun 2009
Offline Last Active Oct 23 2010 05:07 PM
*****

Posts I've Made

In Topic: Fort Detrick Paintball

08 October 2010 - 10:40 PM

Yes we allow walk ons. We are located on Area B of Ft. Detrick, off of Montevue Lane. We are field paint only and cater to walk on players more than anything else.

In Topic: Phantom Undercocking - Pros vs Cons

12 January 2010 - 07:00 PM

no the undercocking kit wont get in the way but the stock one will and you will probably need a new freak back because phantom use their own threads

In Topic: Pump Tourney

09 January 2010 - 10:26 PM

Ok since no one has responded i will assume that there aren't any. If they're are any pump players in the Frederick area (includes PAP, Ft Detrick, and Paintball Sportsland) come on in and post up so maybe we can start something here. This would probably be a "just for fun" thing and i think it would be fun.

In Topic: Worst/Weirdest Jerry-Rigs

31 December 2009 - 11:47 PM

I have found that on some of the old PMR's that when you put the ultralite frame on, the top of the trigger would rub on the solenoid inside the gun and make an extremely sticky trigger when you screwed the back gripframe screw in. So we would always just use the livestrong wristbands tto hold the frame on the gun and they worked fine. Now i keep a fuck-ton of them in my toolbox.

In Topic: superbolt autococker

06 December 2009 - 04:01 PM

Is this a good deal? Yes it's pretty cheap
Does the feedneck come off? yes in two stages, if you just do it in the first stage you can replace it with an intimidator threaded feedneck
How could I convert it to pump?yes you can
How is it in general? it's decent but there kind of hit and miss
How does it perform as a semi? not good because the pneus' are pretty bad
It seems like 70 bucks is a good deal, but it looks kind of suspicious. You will get it

some random notes: They don't seem to be very consistent; me, my friend, and my brother all bought ourselves one and mine was the only one that worked. We wre told that the two that didn't work failed because of a horrible milling job on the inside of the lower tube.