Jump to content


ContractKilla91

Member Since 26 Sep 2008
Offline Last Active Feb 06 2011 10:03 AM
*****

Posts I've Made

In Topic: Vice leaking

06 February 2009 - 02:04 AM

Contact BLAST and see if they can help you over the phone, if not, you will have to send your maker in for repair.

In Topic: What was wrong with angel a1 gen1 markers

06 February 2009 - 02:02 AM

Not a lot of people know how to tech an a1 here in the U.S. The solenoid was always a problem (fries up) so if you got extra money, buy replacement solenoids just in case. Never mess with the LPR! Other than that, it's a highend gun comparable to DMS and Egos


I have never heard of the solenoid being one of the flaws in the Gen. 1's. The list of problems that were fixed were the detent's were too short, the exhaust valve was causing some velocity and pressure problems. The eye covers kept breaking, so they released a more flexible version, then those were replaced by the three piece eye cover's. They also released a lighter hammer in that time frame. There were also some bugs in the software.

In Topic: Vice leaking

06 February 2009 - 01:26 AM

Check your solenoid hoses and make sure they are not pinched or have severe wear.

In Topic: vice leak

06 February 2009 - 01:19 AM

Replace both rammer o-rings and make sure the Poppet o-ring and Cupseal are in good condition.

In Topic: Vice velocity problems

06 February 2009 - 01:17 AM

What is your LPR, Dwell, and ABS at?