Jump to content


largen encharge

Member Since 05 Jan 2010
Offline Last Active Feb 25 2013 09:16 PM
-----

Topics I've Started

pm8 board/trigger problems

23 February 2013 - 12:19 PM

ok, well I have had many issues with my pm8 and had lost a trigger spring, today i modified a pen spring and the trigger is actually returning. BUT, when i turn on the board (hater board not stock) there is no clicking noise. I don't know where to go from here so any suggestions?

glasses fogging

03 August 2012 - 05:17 PM

ok let me start off by saying this, fog has plagued me since the beginning of my paintball career.

my glasses are fogging not lenses

now i do not want anybody to reply saying use anti-fog or to get a fan, I have a fan and anti fog and i have applied it many times and in many ways, DOES NOT WORK
if the anti fog does not work that would mostly likely point to the problem being sweat rolling onto and between the glasses and my face creating moisture and fog

I do not have contacts and would much rather not because of the cost of going to the eye doctor and the cost of the contacts themselves

the only other solution I see are rx goggle inserts which fit to my prescription and fit inside the mask to keep them away from my face which should help............but there $145

as of right now it seems that those are my only 2 options so my question is

does anybody know an alternative that will solve the problem.

good prebuilt

03 July 2012 - 03:00 PM

I am hoping to get a new computer that i may begin to use for gaming. I need a pre built and am looking at anything under $1000 really, but would prefer something more around 700

I am planning to play rpg games (borderlands 2, skyrim, etc) and i would just like a fast computer for basic use

also I am not too concerned with having the best graphics either


this looks decent, though nothing beats building it yourself

http://www.tigerdire...7775&CatId=1887

pm8 trigger does not return

15 June 2012 - 06:04 AM

I believe it is a trigger spring issue but the trigger doesn't really stay in place and when i press it, it goes back and hits the trigger spring and doesn't return at all.

p.s. it's an ironman trigger if that makes much difference.

apex barrel with little effect

27 May 2012 - 10:25 AM

For those who go on this section you will notice i already have questions so here is one more.
I have an sp-1 with a lapco apex ready barrel, I installed my apex tip and it just seem not to have an effect on range or curve
I also have adjusted the rubber flap to the highest setting.