Jump to content


PAINTHEY

Member Since 08 Apr 2010
Offline Last Active Feb 03 2012 11:46 AM
-----

Posts I've Made

In Topic: SP-1 is back

20 July 2012 - 02:38 PM

The neck is the old style and if itís built from the older parts, probably not be milled for eyes. Itíll cost an extra $40 to replace the breach (SP1 to G1 conventions kit), if you want to upgrade to the backhart board. Other than that they are the same gun. Iím a big fan.


In Topic: Do aftermarket barrels really make a gun more accurate?

30 May 2012 - 01:58 PM


Back in the late 90's we used to think spraying RainX, that stuff for car windshields, down a barrel and then polishing with a swab it made it temporarily smoother. More accurate and consistent and able to shoot through breaks.

I think what it probably did, being mostly alcohol, was dissolve and bind some of the oils, dirt and other crap that make their way into the barrel a lot more effectively than just water or Windex. It also dissolved squeegees. :)

It would be cool to do an experiment with it.


Wasn't dri-wash also being used?




Öand Pam cooking spray and Pledge. Ah the good old dark ages.


In Topic: Brony Club!

04 May 2012 - 12:04 PM

I put down my 10€ ($14’ish) for the Seeds of Kindness album. It’s not bad, in fact it’s quite a bit awesome. :tup: http://broniesforgood.org

In Topic: Nitrogen Tanks

26 April 2012 - 09:52 AM

Yes you can. Weld supply places will always have the 3k bulk tanks.


You can also ask for the 5-6k psi nitrogen tanks. Some places will rent those as well. If not, look for big gas suppliers like Airgas of Holox. Iíd recommend a reg on the fill station for those. Donít want someone over filling there tanks.


In Topic: Lapco Barrels

19 April 2012 - 12:44 PM

If you do rec/woods/scenario ball and donít have an apex barrel Iíd recommend the 12 bigshot with apex tip.:tup: