Took my G3 (with virtue board and tech-t bolt) out the other day after not using it for a long time. I had lubed it, and everything looked ok. When i went to chrono it, at first it wouldn't fire at all. Then eventually it did, but the FPS was around 325. So i turned it down a bit and it started to leak out the bottom of the reg. I then turned it back up a bit (less than i had turned it down) and the leak stopped. It was then firing at around 450fps. So i know for a fact that the o-ring in the reg was blown, but i don't see how that could ever cause that. Any ideas? Please help me fix this thing so i can get rid of it.
I just bought a TiPX today and it has a small leak that sounds like it is coming from the Velocity adjusting screw. And the leak will increase as i pull the trigger until i get to a certain point and then it stops. I lubed it, checked the O-rings for any obvious damage and they looked fine. adjusting the velocity and pressure relief screw don't make any noticeable difference. Anyone know why it leaking and how to fix it? I'm planning on calling CS after the weekend but want to see if i can get it solved before then.
looking to start playing pump and found a used VSC phantom black and green acid wash and comes with a tstock. It only has some minor aesthetic wear and supposedly has no leaks or other issues. what would be a reasonable price for something like this? the guy is asking $300
Also as a side note i'm also considering getting a PGP, is $100 a reasonable price for that and any opinions on it would be appreciated.