Jump to content


Demon

Member Since 22 Sep 2010
Offline Last Active Sep 23 2013 04:46 PM
*****

Topics I've Started

ninja burst disks on a crossfire reg?

10 April 2013 - 01:02 AM

i have a crossfire tank and i have had to replace the burst disks twice already, crossfire thinks it's a fantastic idea to use brass fittings which strip like crazy, the ones on my tank are 7k and 1800, can i use ninja 7.5k and 1800 psi burst disks? or do i have to use the brass 7k's?

Vicious Streetball 2012

12 February 2013 - 01:07 AM

http://www.youtube.com/watch?v=yipE6asVdTQ&

http://www.youtube.c...eature=youtu.be

it's offical...

30 October 2012 - 10:30 PM

ABBY! (etekgirl27) is going to win the LL6/nppl bikini contest!

PMR rollback

22 October 2012 - 11:11 PM

hey guys, my friend got a pmr and had be go through it and correct all the problems, i got everything taken care of except he has the rollback issue with the eyes, i have yet to get a chance to contact dye about it, i will tomorrow, but what solutions are there for this? is there someone on the forums who re-drills eyes maybe that is a solution if the eyes are moved up towards the center of the ball and not the bottom? it has a techT L7 bolt in it atm, but i have the stock bolt around here somewhere... happens with both bolts.

thanks guys

ego .50 conversion kit

01 October 2012 - 12:59 AM

so i played with the .50 cal conversion kit in a pink lady 08 ego, it was really tough to get the feedneck insert in, i had to force it in with a rubber mallet. when i shot it at the setting it was at for .68 it shot at 375 fps, i dropped the hpr to where it was 290 but it stopped shooting, closed off the hpr and brought it back to 290 and played the next day. i got a ton of breaks, i couldn't tell if they were chops. and because i didn't have a .50 squeegee i couldn't clean the barrel except for running water through it. but overall it shot pretty straight until it chopped and i liked it alot.

on sunday morning i cleaned it out again and i took the lpr screw out, dropped the dwell to 8 ms in the hopes it would be easier on paint. took it out today and it only broke paint like twice all day, so a bit better but still not great. i also found out that in a pinch the cheap JT swabs can be jammed through the .50 barrel and work well but they are tough to force through, a very tight squeeze.

i was using jt splatmaster paint and i even kept it in the sun on saturday in the hopes it would firm up some and stop breaking but it didn't really. still not sure about the breaking paint issue but i can't easily set it back to .68 as i have no idea how to get the feedneck insert out without causing damage to it or the marker, i am pretty dissapointed that the insert didn't go in as it should have easily dropping down.