Jump to content


CdTriX

Member Since 11 Feb 2011
Offline Last Active May 22 2013 01:17 PM
*----

Topics I've Started

How to install Eigenbolt in a Vice

29 November 2012 - 12:25 AM

just got my eigenram and I have no idea wtf i'm suppose to do with it. The instructions are vague.

so it comes with a brass insert or the black "spacer" that looks like macroline, so which one do I use with a pillow bolt?

what is the ram bumper suppose to look like?

Where to get paint in GTA?

06 August 2012 - 10:53 AM

I'm on the west side and the only place i can get paint is from badlands... they are in the shittiest location and i work near there...

where do you guys get your paint?

Autococker bolt pin detent

26 July 2012 - 06:20 PM

What's the screw size for the screw that goes into the back of the stock bolt that holds the spring and ball detent for the bolt pin?

Just started pumping

04 July 2012 - 12:41 PM

I'm in between beginner and intermediate as a speedball player. So pumping is going to be tough.

Just got a blue psychoballistics super bolt, with i believe a hooptie pump kit, deadlywinds 14 inch fibur barrel, blue CP reg, and a ghetto on off. It is ridiculously quiet.

I was playing against some speed ballers and I was working on snapshooting. That one shot, where i pumped, waited for him to pop out, pulled the trigger, and got him in the face... it was like pure bliss. It was an indescribable feeling of only shooting 1 ball and getting him in the face. I'm having a lot of trouble aiming :*(. Are there any tricks to aiming?

Pump is tough!

Holds air pumped, leaks air after shot until pumped again

03 July 2012 - 08:20 AM

Just got my psychoballistic superbolt + hooptie pump kit.

Everything is installed properly, aired it up. holds air. take a shot... leaks air out the barrel. If i pump it again or recock the gun, it holds air.

The gun is brand new, I checked the valve and it's in good condition, the IVG is not all the way in. the reg is untested since i just got the CP reg used but it was doing it with another CP reg off my 04 prostock.

The cp reg is backed out about 3/4 of the way out ( i know i need to sweetspot it ).

it's not leaking out of the front block adapter and i don't have the pump arm setup too tight.

I have an ANSGEAR valve setup (it's currently leaking :S) but it essentially does the same thing. Any help would be appreciated.