Jump to content


SPEEDJUICE

Member Since 15 Mar 2011
Offline Last Active Jun 07 2011 08:56 PM
-----

Topics I've Started

Ego Pops ASA

07 June 2011 - 08:25 PM

I was taking apart my pops asa to clean and lube it and when I put it back together its leaking out the front!! wtf! Can someone me if there is 1 very small o-ring on each side of the floating pin??

Dwell Setting

01 June 2011 - 09:21 PM

Quick question, If Im running my dwell at 14, And feel my efficientcy is for shit! And decide to turn it down to 12, & even possibly 11! I know I will lose Volocity, But should'nt I be able to make it back up by simply adjusting my Volocity Reg, and through this process won't I be running more efficient by saving air? OR> Is it just an off-set because the air I think Im savin by turning the Dwell down, Im screwing myself by turning up the Reg????? Thanks Everyone (ETEK 3am, Virtue Board, Zick-Kit 2, Tech Hush-Bolt, Pops ASA)


Bob Long 2k2 Intimi, MAJOR LEAK?

03 May 2011 - 05:43 PM

The a are 3 external adjustments on this marker, the bottom of the REG, the front of the LPR, and the Rear Cap for the rammer, there is a allen screw, could someone tell me where these 3 screws should be for a nuteral(Default setting) should be, EXAMPLE: On my new ETEK AM, they say on the LPR, when the allen adjustment screw is all the way out "flush" with the cap, you screw it in 1-1/2 to 2 turns in. which one of the 2 screws on the timmy, adjust volocity?? "Botton of the Reg" OR the screw cap closing up the rammer housing??

RE-Useable .068 Balls.."Target Advice"? HELP!

30 April 2011 - 02:12 PM

I just picked up 300 yellow re-useable rubber balls, Is there anyone out there that can give me some advice as to some type of home made "Target System" they have used in the past?? I made up a half ass target and balls were flying everywhere !lol and at the cost$$ on them Im not real fond of losing them! I want to rig up some kind of "Target Trap" so that they hit the target but also stay in it (confined). Example: I took a 2-shelf book case that is about 3ft tall, I took the shelves out and sat the case up on a chair in the driveway, and drapped a bath towel over it, and the end of the towel went to the bottom of the book-case, and because it was sitting on a chair it was slightly tilted back, so the shots hit the towel and went down, and rolled back into the case, that worked fine on semi-auto, but as soon as I went to ramping, or any other high profile mode, All Hell Broke Loose! one actually flew back and I had to duck!!! lol! This was at approx 15 yrds away..... any ideas would be greatly appreciated.

REUSABLE .068 BALLS

23 April 2011 - 09:31 AM

Can anyone give me some feedback on Reusable balls which brand they liked, most durable, do they all need to be shot at 240 basically anything you can tell me is great thanks