Jump to content


ic3man211

Member Since 31 May 2011
Offline Last Active Jul 19 2014 08:41 PM
-----

Posts I've Made

In Topic: lube trigger?

26 April 2013 - 12:54 PM

alright thanks :)

In Topic: How important is a carbon fiber tank?

04 November 2012 - 02:53 PM

Ninja is the most recommended and not without good reason. Solid company and fail to disappoint.

In Topic: Is the vlocity still a super loader?

18 July 2012 - 10:11 PM

I would still consider it a super loadaer. what defines super loader, over $100 or able to feed 50 bps when everything is capped ad 12.5. its light and works amazing if you take care of it so yea its still a super loader. :)

In Topic: Autococker help

12 July 2012 - 07:54 AM

best bet is to go to a store who has people that know autocockers and see if they can help because if they've owned autocockers most likely they will own a valve tool.

In Topic: stripped screw help!

01 July 2012 - 07:09 PM

didnt know how to explain drilling out a screw so look at this



Drill out the entire screw as a last resort, and only if the screw is holding together metal objects
. If all else fails, it is possible to drill out the existing screw with a power drill and bit of the same size as the screw's shaft. This will most likely remove the existing thread. Possible solutions at this point:



Posted Image
  • Replace old screw with a self-tapping (thread-forming) screw of slightly larger size.
  • Use a nut and bolt instead. If desired, weld the nut to one of the metal objects to create a stationary, threaded mount.
  • If the screw was large enough, install a HeliCoil insert.