Jump to content


1pump1kill

Member Since 03 Sep 2011
Offline Last Active Oct 25 2011 09:12 AM
-----

Posts I've Made

In Topic: Good jumping off point?

25 October 2011 - 09:09 AM

A few drops of oil into the ASA and the bolt if it has o-rings, dry fire a bit, and that's it for maintenance. You only have to sweet spot your regulator once unless the adjustment screw for it tends to unwind and adjust your IVG if needed.

A valve tool is handy if your restoring an Autococker/Sniper that has a worn out valve o-ring or cup seal, re-springing for an lp set-up, or eliminating the fart noise by swapping out both the valve and hammer spring.. Other than that, you don't need one.

It's all about the pump handle and if that's comfy for you to grip. I like WGP/Team Hooptie ones over CCM any day.

In Topic: How fast do you run your mile?

24 October 2011 - 07:32 PM

8-830 for me. I'm more of a distance runner though. I think of being able to outrun zombies for miles without gassing out :P

In Topic: Stock Class harness?

23 October 2011 - 06:32 AM

I've owned all 3.

< $30 is as good as you can find them.

I prefer the Ronin suspenders overall.

I spaced out my tubes with speed caps on the waist belt. 5 on each side. Then the 12 grams are spaced out as well on the suspenders with 3 tubes on the lower left suspender strap. It's easier to grab the tubes out for me and I don't accidentally pull the cover off and lose paint..

In Topic: Violent Series lubes?

21 October 2011 - 10:31 AM

It's okay to put oil on the o-rings on a delrin bolt, but not on the bolt itself...

I never heard of that type of lube.

Air Tool oil from your local hardware store is your best bang for your buck.. It's almost the same stuff that they sell to everyone in those $7 small bottles.

In Topic: Nexus DC's

21 October 2011 - 10:20 AM

Check on MCB. The guy is asking $1000+ IIRC.