Jump to content


ImAnExtremist

Member Since 20 Jan 2012
Offline Last Active Jan 18 2013 04:44 PM
-----

Posts I've Made

In Topic: Gryphon Upgrades

02 March 2012 - 05:14 PM

Stay away from the Gryphon. Save up your money and go for a GoG gun.

In Topic: GoG G1 Help!

01 March 2012 - 07:41 PM

Cookie, I NEVER forget anything.

Why dont you set the dwell yourself?

If you have a blackheart set dwell to 30ms. If its not, set to hpa. You should get to know your marker. Dont take the word of the owner.

ALSO MAKE SURE YOU ARE USING A FRESH DURACEL OR ENERGIZER ONLY!!

Its not the bolt. It might be the pressure. But im 99% sure its one of the above. You can take a look at my troubleshooter in my sig but it should tell you the same.


Thanks, I'm currently fiddling with the settings! I'll get back to you.

In Topic: GoG G1 Help!

01 March 2012 - 02:34 PM


I coated the bolt completely with lube...

...Owner says it might be bolt stick, but I highly doubt it.

Yea...

Take the bolt out and wipe it all off, then take a piece of grease half the size of a pea and use that for the entire bolt, if it still does it with that small an amount of lube its not bolt stick.


I did this, and it was working for a short period of time. The chrono was 120, 184, 250. I kept adjust it little by little, and now it stopped working. When I lowered it back down, it still did the "puff" sound, and the ball rolled out of the barrel.

In Topic: GoG G1 Help!

01 March 2012 - 09:20 AM

I coated the bolt completely with lube, there's no leaks, no qev, owner says the dwell was set for HPA.

Let me describe the problem.

I can dry fire the gun, and the bolt cycles properly. Whenever there's a paintball in the breach, the bolt slightly strikes it, but only a puff of air comes out; letting the ball roll out of the barrel. Sometimes when I dry fire it, I can hear that puff, but not always.

When there's a paintball in the breach, I can see the bolt moving forward, striking it, and cycling back.

Owner says it might be bolt stick, but I highly doubt it.

I really need help with this.

In Topic: EMPIRE AXE

29 February 2012 - 09:53 PM

Put in a fresh battery, reset your board to stock settings. Were you using CO2? That fluctuation is pretty crazy.



I don't think you can use C02 with an Empire Axe.

But heck, I could be wrong.