Jump to content


TheMason

Member Since 08 Dec 2012
Offline Last Active Jan 10 2013 01:48 PM
-----

Topics I've Started

Replacing 007 o ring on hyper 3 reg

29 December 2012 - 07:02 PM

So I was doing some reg maintenance and I took out the existing 007 o ring cuz it looked jacked up... Now I can't get a new one in there.

Anyone have any ideas?

Ps - I have a pm8

PBC Rock Hill Update

15 December 2012 - 02:25 PM

Played PBC Rock Hill today. Not sure if this is new or not, but they now have a 4500 PSI full station, and it was the first time I had seen it.

Etek 4 AM and Emortal Board

12 December 2012 - 09:54 AM

So I bought an etek 4 AM, and saw in the manual that you can put it in the gun, but nothing online says you can, or for that matter can't, and tech team at planet eclipse sucked and could not tell me if existing emortal board would work or not on the etek 4 AM.


Any thoughts?

Great Customer Service - NOT!

12 December 2012 - 09:51 AM

So I called Planet Eclipse and reach out to tech support because i bought a new etek 4 AM, and saw in the manual that you can use the emortal board on the etek 4 (as loang as it is AM); however, everything I've read says it only works on the etek 3 AM, and their site doesn't meantion the etek 4 AM either.

I mentioned this to the tech, and he was literally like "DUH, I don't know. There are some differences between the functional of the stock boards from the 3 to the 4, but I don't know if the existing emortal board would work or not."

Me: "But it's in your manual, what do you mean you don't know?"

Him: "I'm not sure. I don't know."

Me: "Thanks for the help buddy."

So now I'm half tempted to send the gun back.

Proto PM8 Leak

08 December 2012 - 11:52 AM

I was in the process of doing some work to my pm8 the other day, replacing O-rings, etc, because my gun wasn't shooting/firing and I was worried it might be bolt stick, a noid issue, etc. Ultimately figured out it was a noid issue, and got that resolved.

Then I turned the pressure up on on my reg (stock) because my gun was shooting at 150 fps, potentially too high, and the gun started spewing air out of the front of the gun and through the feednack (I did not have my hopper on) at a high rate. Also, while the gun was firing the bolt did get stuck, UGH, so I went and re-lubed everything.

Anyway - any ideas on what I need to do to fix the air leak issue? First time that has happened to me.

Thanks,

M