Jump to content


ryanporter10

Member Since 11 Dec 2012
Offline Last Active May 30 2014 03:24 PM
-----

Topics I've Started

bob longs, ng's g6rs and v2's

30 May 2014 - 07:35 AM

Okay so im screwing around on my local bst and was offered a trade, my geo2.05 for and insight ng. Are Bob longs reliable? Are parts easy to find (in Canada) and how old are insights?? I remember hustle put out a review not a year ago and they're already off the shelf. On another note, are g6rs or v2's worth the money and reliable?

driving in chiraq

10 May 2014 - 04:47 PM

i have a slight issue which i am in need of advice.

my 2 idiot friends are coming down from canada with me, and we are all 17. I have my G2(essentially a full license except i cannot have more than 3 other teens in the car with me after midnight, and i pay out the rear for insurance) but i have recently caught rumor that i cannot drive with a g2 in the US with any other teens/no adult. i have looked THROUGH THE DEPTHS OF THE INTERNET and have not found a sure answer, only "well i think" and "you'll PROBABLY be ok" . does anyone know for sure because if not well then im might be screwed, because i look about 12 years old and the chances of me getting pulled over are rather high.

on another note, is the food available at the event overpriced like a movie theater or reasonable?


just got a pump.. problems already occuring

25 June 2013 - 12:32 PM

I recently got a used check-it mini orracle v2.
I THINK the bolt is not stock, because it goes PAST the detents, yes, when the pump handle is all the way forward, it is infront of the d-tents, and the balls just roll out of the barrel.
As for as i know, the bolt should have a notch cut out for the d-tent as well, although it does not.
is my bolt too long/not stock?

ma new pump

24 June 2013 - 09:41 PM

Ma new pump is a cip mini sniper v2. This is my first pump, AND autococker(no it doesn't have pneumatics, but you get it)
do i need to "sweet spot it", or just adjust velocity and go?
should i adjust velocity the way cip says(through IVG), or through reg?
do i just turn the cocking rod all the way in?
THANK YOU FOR YOUR RESPONSES, even though i have looked through internet as much as possible, still a bit confused.

barrel?

19 June 2013 - 12:49 PM

wellllllll i just got my first stack-tube poppet, and i need silenceeee!

what the barrel with the most porting/quietest one out there