Jump to content


dosh

Member Since 16 Mar 2013
Offline Last Active May 12 2013 09:07 PM
-----

Posts I've Made

In Topic: Tips for playing in rain

08 May 2013 - 07:27 PM

Start your slides alot earlier than you normally would. You'll be amazed how far you can go on wet grass.

In Topic: I did a bad!

08 May 2013 - 09:12 AM

Take it back apart and look for pinched wires. Also check to see if the connectors are seated correctly.

In Topic: Hopper Question

07 May 2013 - 04:45 PM

And convenience.

In Topic: Hopper Question

07 May 2013 - 04:22 PM

What exactly didn't you like about the Rotor?
I find it funny how everybody seemed to glaze over that before posting. Who knows? Maybe the reason the OP didn't like the Rotor could also be applied to the other hoppers people are recommending, thus recommending something the OP is bound to dislike.



That happens with all kinds of products on here. Your loader just has to feed faster than you can shoot and not break. For laying paint down how much difference is there between an old HALO B and any of the newer loaders? None. Pick what you like, stick it on your gun and shoot ropes. It's actually really nice that the performance aspect has been removed to such a degree that aesthetics can be the deciding factor.

In Topic: Mask Cleaning

03 May 2013 - 04:37 PM

Break it down then rinse the lens off and the frame. You want to rinse the lens off before you touch it with any kind of cloth to wash away any dirt or loose particulate matter. If you leave it up there, or just spritz the lens with a cleaning solution the dirt will grind between the lens and the cloth scratching it. Myself I don't use anything but water and toilet paper on my lenses, but microfiber works well too.

For the frame a mild solution of water and dish soap works well. Rinse it off, clean with a rag, rinse again, and allow to dry before reassembling.