Jump to content


bubbagooch

Member Since 28 Apr 2013
Offline Last Active Jun 17 2013 01:34 AM
-----

Posts I've Made

In Topic: Autococker issues. Help greatly appreciated.

05 June 2013 - 12:48 AM

So I re-lubed the o-rings and shortened the length of the rod and it seems like it's all good. I can't test it out now because it's late, but I will tomorrow. Thanks.

In Topic: Autococker issues. Help greatly appreciated.

04 June 2013 - 09:11 PM

It sounds to me like you need to lengthen the trigger rod. If the rod is too short, then the ram actuates the back block when airing up.






http://www.endlesspb...ech/timing.html

this should help. Check the part about the actuator rod.



I tried that. I adjusted it incrementally and at a certain point it makes it so that I can't pull the trigger anymore and the backblock issue is not fixed. I also tried shortening it and all that happens is that it starts to leak out of the front of the 3-way if I make it too short, and the backblock issue is still not fixed.

In Topic: Antonious' Feedback

04 June 2013 - 03:51 AM

Bought an autococker trigger frame and an o-ring kit. It took a while to get it shipped because he was busy with work, but he let me know what was going on and I was okay with it because I wasn't in any hurry. Once the item shipped I received it quickly and as described. I'd do business again.

In Topic: CCI Phantom Questions

31 May 2013 - 05:25 AM

You would need to get a body like THIS for that to work and I think they are CCM threads but I'm not sure.

In Topic: Autococker O-ring kit and Dye Hinge Frame; Alum. Ion body; Sexy Work Mat

25 May 2013 - 09:04 PM

LOL. I can do that.